Motorized PCB Depanelizer 1200mm Length LED Strip Automatic Cutting Machine

Motorized PCB Depanelizer 1200mm Length LED Strip Automatic Cutting Machine

Pcb Cutting Machine advantages :

1. Separates large numbers of PCBs without fatigue of the operator

2. Motor driven

3. The PCB is feed between the circular blades where it is seized, transported and separated

4. Different speeds can be selected

Specification for PCB Cutting Machine :

PCB Cutting Machine Features :

1 . It is electric control,the straight knife type separator machines were designed to separate pre-scored panel boards carefully, without bending or tension stress . Even sensitive SMD-components like ceramic capacitors will not be damaged by the separate process . Due the special design of the knives also boards with high components placed closed to the edages can be separated safely .

2 . No vibration during the process to prevent damage to precise PCB

3 . Gap for insertion of the board can simply be adjusted by means of the adjusting knob , low friction design is applied

4 . Lower knife height adjustable , no thin plates are required after re-sharpening the cutting blade

5 . It is safty .the plastic shell can protect the operators .

6 . The blades can be regrind .

PCB Separator Equipment Introduction :

1. With unique cutting method , the circuit board is cut by six blades . It is a group composed of one upper

and one lower blade , and is also a cutting unit. There are A, B, C, three groups. The whole cutting

process is divided into three stages from group A blade which cut 40% board then to the group B blade

knife cut through groove cutting by group A to complete another 40% .the last 20% is cut by group C

blade and finishing. because each cutting volume is small, the stress produced during the cutting

progress declined by more than 80% compared with the traditional cut off at a time. Thus the edge of the

board and its surface are very smooth without warping . Currently, it is the only machine that can

guarantee the aluminum plate without deformation after cutting .
 

2. Because cutting force of the blade is small. abd with high speed steel material which is imported from

the Swedish. durability of the blade greatly improved , and the lifetime can be one year or more when

cutting the aluminum board.

3. All the cutting blades are calibrated by Excitation double-frequency laser interference measurement

instrument. Ensure that the latter knife can accurately continue to cut in the slots which already cut by the

former knife.The jitter of knife point is less than 0.02mm. Ensure perfect cutting quality.